(1) As Terry alluded to, his experience is that the American Standard products now are very hit or miss as to whether you'll get a defective one. should I just wing it? Do the slots for the closet bolts offer a lot of adjustment? How much could I be off and not have anyone notice? How do I align the ring properly? What do I use as a reference? The walls aren't square like most houses aren't, and I have no vanity yet. Carbide pre-drill through the tile and then stainless screws into sub-floor?ģ. the metal ring will spin around and need screws to hold it down. Is there a better flange to use in this instance?Ģ. but I have at least an inch for primer and glue.ġ. Its one that fits inside a 4 inch pipe or onto a 3" pipe. The flange is just stuck into the pipe for alignment purposes. In the picture below, the tiles around the edges of the room (including the one under the flange) are just sitting on the floor- no thinset yet. I have 12 3/4 inches from the wall to the center of the pipe, the toilet says 12" rough in. American Standard Champion 4 (they got me on the hotdog flushing videos). I'm tiling my floor and will soon be installing the toilet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |